ProLiant DL160 Gen10 Server

QuickSpecs
HPE ProLiant DL160 Gen10 Server
Standard Features
Page 6
Expansion Slots
FlexibleLOM Riser
Slots #
Technology
Bus
Width
Connector Width
Slot Form Factor
Notes
1
PCIe 3.0
X8
X8
Flexible LOM
Proc 1
2
PCIe 3.0
X8
X8
Half-height,
half-length slot
Proc 1
NOTE: Bus Width Indicates the number of physical electrical lanes running to the connector.
NOTE: This riser is mandatory for installing FlexibleLOMs
NOTE: FlexibleLOM riser will replace standard CPU1 X16/X8 riser.
CPU2 Riser
Slots #
Technology
Bus
Width
Connector Width
Slot Form Factor
Notes
1
PCIe 3.0
X16
X16
Half-height,
half-length slot
Proc 2
NOTE:
Bus Width Indicates the number of physical electrical lanes running to the connector.
NOTE: When populating the second optional riser slot, the second processor must be installed.
NOTE: Cannot be installed if type-a modular smart array controller is installed.
NOTE: Max 3-PCIe slots are available on the DL160-Gen10.
Storage Controllers
The Gen10 controller naming framework has been updated to simplify identification as depicted below. For a more detailed brea
kout
of the available Gen10 Smart Array controllers visit the HPE Smart Array Gen10 Controllers Data Sheet.
One of the following depending on model
Software RAID
HPE Smart Array S100i SR Gen10 SW RAID
NOTE: HPE Smart Array S100i SR Gen10 SW RAID will operate in UEFI mode only. For legacy support an
additional controller will
be needed.
NOTE: HPE Smart Array S100i SR Gen10 SW RAID is off by default and must be enabled.
NOTE:
HPE Smart Array S100i SR Gen10 SW RAID only supports Windows and does not support Linux. For Linux users, HPE
offers a solution that uses in-distro open-source software to create a two-
disk RAID 1 boot volume. For more information
visit: https://downloads.linux.hpe.com/SDR/project/lsrrb/
Essential RAID Controller
HPE Smart Array E208i-a SR G10 LH Controller
HPE Smart Array E208i-p SR Gen10 Controller
HPE Smart Array E208e-p SR Gen10 Controller
Performance RAID Controller
HPE Smart Array P408i-a SR G10 LH Controller
NOTE: Performance RAID Controllers require the HPE Smart Storage Battery (P01366-B21) which is sold separately.