User Manual

Item Description Status
1 UID button/LED
Solid blue = Activated
Flashing blue:
• 1 flash per second = Remote management or
firmware upgrade in progress
• 4 flashes per second = iLO manual reboot sequence
initiated
• 8 flashes per second = iLO manual reboot sequence
in progress
Off = Deactivated
2 NIC status LED
Solid green = Link to network
Flashing green (1 flash per second) = Network active
Off = No network activity
3 Health LED
Solid green = Normal
Flashing green (1 flash per second) = iLO is rebooting
Flashing amber = System degraded
Flashing red (1 flash per second) = System critical
If the health LED indicates a degraded or critical state,
review the system IML or use iLO to review the system
health status.
4 Power On/Standby button and
system power LED
Solid green = System on
Flashing green (1 flash per second) = Performing power
on sequence
Solid amber = System in standby Off = No power
present
If the system power LED is off, verify the following
conditions:
• The facility power is present.
• The power supply is installed and is working
correctly.
• The power cord is attached and is connected to a
power source.
• The front I/O cable is connected.
When all four LEDs described in this table flash simultaneously, a power fault has occurred. For more
information, see Power fault LEDs on page 12.
10 Component identification