User Manual
Table Of Contents
- HPE ProLiant DL160 Gen10 Server User Guide
- Contents
- Important product information
- Component identification
- Setup
- Operations
- Power up the server
- Powering down the server
- Extend the server from the rack
- Access the product rear panel
- Remove the server from the rack
- Removing the front bezel
- Remove the access panel
- Installing the access panel
- Removing the primary PCI riser blank
- Installing the primary PCI riser blank
- Removing the primary PCI riser cage
- Installing the primary PCI riser cage
- Removing the secondary PCI riser cage
- Installing the secondary PCI riser cage
- Removing the expansion slot blank
- Removing and replacing a drive blank
- Hardware options installation
- Introduction
- Installing the front bezel option
- Redundant power supply enablement option
- Power supply options
- Memory options
- Drive options
- Installing a two-bay SFF enablement kit
- Installing the Slim SSD enablement kit
- Redundant fan option
- Installing the optical drive
- Installing the Media Module
- Installing the FlexibleLOM
- Installing the serial port
- Expansion board options
- Storage controller options
- Processor heatsink assembly option
- Installing the Chassis Intrusion Detection switch
- Smart Storage Battery option
- M.2 SSD enablement option
- HPE Trusted Platform Module 2.0 Gen10 option
- Cabling
- Software and configuration utilities
- Troubleshooting
- System battery replacement
- Specifications
- Safety, warranty, and regulatory information
- Websites
- Support and other resources
• HPE 800W Flex Slot Titanium Hot-plug Low Halogen Power Supply on page 132
• HPE 800W Flex Slot Universal Hot-plug Low Halogen Power Supply on page 133
For detailed power supply specifications, see the QuickSpecs on the Hewlett Packard Enterprise
website.
HPE 500W Low Halogen Non-hot-plug Power Supply
Specification Value
Input requirements —
Rated input voltage
100 VAC to 240 VAC
240 VDC for China only
Rated input frequency 50 Hz to 60 Hz
Rated input current
5.8 A at 100 VAC
2.3 A at 240 VAC
2.7 A at 240 VDC for China only
Maximum rated input power
578 W at 100 VAC
557 W at 240 VAC
BTUs per hour
1953 at 100 VAC
1882 at 240 VAC
Power supply output —
Rated steady-state power
500 W at 100 VAC to 240 VAC input
500 W at 240 VDC input for China only
Maximum peak power
500 W at 100 VAC to 240 VAC input
500 W at 240 VDC input for China only
HPE 500W Flex Slot Platinum Hot-plug Low Halogen Power Supply
Specification Value
Input requirements —
Rated input voltage
100 VAC to 240 VAC
240 VDC for China only
Rated input frequency
50 Hz to 60 Hz
Not applicable to 240 VDC
Table Continued
130 Specifications