User Manual
Table Of Contents
- HPE ProLiant DL160 Gen10 Server User Guide
- Contents
- Important product information
- Component identification
- Setup
- Operations
- Power up the server
- Powering down the server
- Extend the server from the rack
- Access the product rear panel
- Remove the server from the rack
- Removing the front bezel
- Remove the access panel
- Installing the access panel
- Removing the primary PCI riser blank
- Installing the primary PCI riser blank
- Removing the primary PCI riser cage
- Installing the primary PCI riser cage
- Removing the secondary PCI riser cage
- Installing the secondary PCI riser cage
- Removing the expansion slot blank
- Removing and replacing a drive blank
- Hardware options installation
- Introduction
- Installing the front bezel option
- Redundant power supply enablement option
- Power supply options
- Memory options
- Drive options
- Installing a two-bay SFF enablement kit
- Installing the Slim SSD enablement kit
- Redundant fan option
- Installing the optical drive
- Installing the Media Module
- Installing the FlexibleLOM
- Installing the serial port
- Expansion board options
- Storage controller options
- Processor heatsink assembly option
- Installing the Chassis Intrusion Detection switch
- Smart Storage Battery option
- M.2 SSD enablement option
- HPE Trusted Platform Module 2.0 Gen10 option
- Cabling
- Software and configuration utilities
- Troubleshooting
- System battery replacement
- Specifications
- Safety, warranty, and regulatory information
- Websites
- Support and other resources
Specification Value
Rated input current
5.8 A at 100 VAC
2.8 A at 200 VAC
2.4 A at 240 VDC for China only
Maximum rated input power
557 W at 100 VAC
539 W at 200 VAC
537 W at 240 VDC for China only
BTUs per hour
1902 at 100 VAC
1840 at 200 VAC
1832 at 240 VDC for China only
Power supply output —
Rated steady-state power
500 W at 100 VAC to 127 VAC input
500 W at 100 VAC to 240 VAC input
500 W at 240 VDC input for China only
Maximum peak power
500 W at 100 VAC to 127 VAC input
500 W at 100 VAC to 240 VAC input
500 W at 240 VDC input for China only
HPE 800W Flex Slot Platinum Hot-plug Low Halogen Power Supply
Specification Value
Input requirements —
Rated input voltage
100 VAC to 127 VAC
200 VAC to 240 VAC
240 VDC for China only
Rated input frequency
50 Hz to 60 Hz
Not applicable to 240 VDC
Rated input current
9.1 A at 100 VAC
4.4 A at 200 VAC
3.6 A at 240 VDC for China only
Maximum rated input power
899 W at 100 VAC
867 W at 200 VAC
864 W at 240 VDC for China only
Table Continued
Specifications 131