User Manual
Table Of Contents
- HPE ProLiant DL160 Gen10 Server User Guide
- Contents
- Important product information
- Component identification
- Setup
- Operations
- Power up the server
- Powering down the server
- Extend the server from the rack
- Access the product rear panel
- Remove the server from the rack
- Removing the front bezel
- Remove the access panel
- Installing the access panel
- Removing the primary PCI riser blank
- Installing the primary PCI riser blank
- Removing the primary PCI riser cage
- Installing the primary PCI riser cage
- Removing the secondary PCI riser cage
- Installing the secondary PCI riser cage
- Removing the expansion slot blank
- Removing and replacing a drive blank
- Hardware options installation
- Introduction
- Installing the front bezel option
- Redundant power supply enablement option
- Power supply options
- Memory options
- Drive options
- Installing a two-bay SFF enablement kit
- Installing the Slim SSD enablement kit
- Redundant fan option
- Installing the optical drive
- Installing the Media Module
- Installing the FlexibleLOM
- Installing the serial port
- Expansion board options
- Storage controller options
- Processor heatsink assembly option
- Installing the Chassis Intrusion Detection switch
- Smart Storage Battery option
- M.2 SSD enablement option
- HPE Trusted Platform Module 2.0 Gen10 option
- Cabling
- Software and configuration utilities
- Troubleshooting
- System battery replacement
- Specifications
- Safety, warranty, and regulatory information
- Websites
- Support and other resources
PCIe expansion slot definitions
Slot Type Form factor Connector link
width
Negotiable link
width
Supported
expansion
board
1
PCIe 3.0
FlexibleLOM
HL, FH
1
FlexibleLOM
x16
x8
16, 8, 4, 1
Four-port 1 GB
NIC card
2
M.2 SSD
enablement
board
2
PCIe 3.0 HL, HH
3
x8 8, 4, 1
Ethernet NIC
cards (10 GB or
higher)
4
Smart Array PCIe
plug-in controller
M.2 SSD
enablement
board
3
PCIe 3.0 HL, HH
3
x16 16, 8, 4, 1
Four-port 1 GB
NIC card
2
Ethernet NIC
cards (10 GB or
higher)
4
M.2 SSD
enablement
board
1
HL, FH=Half length, full height
2
This server supports a maximum of two four-port 1 GB NIC cards.
3
HL, HH=Half length, half height
4
This server supports only one Ethernet NIC card.
PCIe slot description
Component identification 15