ProLiant DL360 Gen10 Server
Table Of Contents
- Overview
- Platform Information
- Standard Features
- Optional Features
- Service and Support
- Pre-configured Models
- SMB Models
- Configuration Information - Factory Integrated Models
- Core Options
- Additional Options
- Memory
- Storage
- Technical Specifications
- Summary of Changes
- a00008159enw - 15929 - Worldwide - V15 - 6-August-2018
QuickSpecs
HPE ProLiant DL360 Gen10 Server
Standard Features
Page 8
NOTE: For General Server Memory and NVDIMM Population Rules and Guidelines for Gen10 see details
here: http://www.hpe.com/docs/memory-population-rules
Memory Protection
Advanced ECC
Advanced ECC uses single device data correction to detect and correct single and all multibit error
that occurs within a single DRAM chip.
Online Spare
Memory online spare mode detects a rank that is degrading and switches operation to the spare
rank.
NOTE: For more information see our Memory RAS feature technical whitepaper.
Expansion Slots
Primary
GPU Riser
Expansion
Slots #
Technology
Bus
Width
Connector
Width
Processor
Slot Form Factor
1
PCIe 3.0
x16
x16
CPU1
Full-height, 3/4 length (up to 9.5in)
2
PCIe 3.0
x8
x8
CPU1
Low Profile
Primary
SATA M.2 Riser
Expansion
Slots #
Technology
Bus
Width
Connector
Width
Processor
Slot Form Factor
1 PCIe 3.0 x16 x16 CPU 1 Full-height; 3/4 length (up to 9.5in)
2 PCIe 3.0 x16 x16 CPU 1 Low Profile
Primary
NVMe Riser
Expansion
Slots #
Technology
Bus
Width
Connector
Width
Processor
Slot Form Factor
1 PCIe 3.0 x16 x16 CPU 1 Full-height; 3/4 length (up to 9.5")
2 PCIe 3.0 x8 x8 CPU 1 Low Profile
Secondary
Riser*
Expansion
Slots #
Technology
Bus
Width
Connector
Width
Processor
Slot Form Factor
3 PCIe 3.0 x16 x16 CPU 2
Low Profile or
Full-height; 3/4 length (up to 9.5")
NOTE: If secondary full height kit is installed, then primary PCIe Slot #2 cannot be used. Only 2 full height slots are
supported.
Storage Controllers
Software RAID
HPE Smart Array S100i SR Gen10 SW RAID
NOTE: HPE Smart Array S100i SR Gen10 SW RAID will operate in UEFI mode only. For legacy support an additional
controller will be needed, and for CTO orders please also select the Legacy mode settings part, 758959-B22.
NOTE: HPE Smart Array S100i SR Gen10 SW RAID is off by default and must be enabled.
NOTE: The S100i is a 14-port SATA controller, but only 12 ports are accessible as 2 are leveraged to support the 2 M.2
options on the Primary Riser.
NOTE: The S100i supports windows only.
NOTE: For Linux users, HPE offers a solution that uses in-distro open-source software to create a two-disk RAID 1 boot
volume. For more information visit:
https://downloads.linux.hpe.com/SDR/project/lsrrb/
Essential RAID Controllers
HPE Smart Array E208i-a SR Gen10 Controller
HPE Smart Array E208i-a SR G10 LH Controller