Product Data Sheet / Brochure

QuickSpecs
HPE ProLiant DL380 Gen10 Plus Server
Standard Features
Page 11
Power Supply
• HPE 800W Flex Slot Platinum Hot Plug Low Halogen Power Supply Kit
Notes:
- Available in 94% and 96% efficiency.
- Also available in -48VDC and 227VAC/380VDC power inputs.
• HPE 1600W Flex Slot Platinum Hot Plug Low Halogen Power Supply Kit
Notes: 1 available in 94% efficiency.
HPE Flexible Slot (Flex Slot) Power Supplies share a common electrical and physical design that allows for hot plug, tool-less
installation into HPE ProLiant Gen10 Plus Performance Servers. Flex Slot power supplies are certified for high-efficiency operation
and offer multiple power output options, allowing users to "right-size" a power supply for specific server configurations. This
flexibility helps to reduce power waste, lower overall energy costs, and avoid "trapped" power capacity in the data center.
The standard 6-foot IEC C-13/C-14 jumper cord (A0K02A) is included with each standard AC power supply option kit. If a
different power cord is required, please check the ProLiant Power Cables web page. o review the power requirements for your
selected system, please use the HPE Power Advisor Tool.
For information on power specifications and technical content visit
HPE Server power supplies
.
Storage Controllers
The Gen10 Plus controller naming framework has been updated to simplify identification as depicted below.
For a more detailed breakout of the available Gen10 Plus Smart Array controllers visit the sites:
HPE Smart Array Gen10 Plus MegaRAID Controllers Data Sheet Or
HPE Smart Array Gen10 Plus SmartRAID Controllers
Data Sheet
One of the following depending on model
Software RAID
• HPE Smart Storage SR100i Gen10 Plus SW RAID
Notes:
− HPE Smart Array S100i SR Gen10 SW RAID will operate in UEFI mode only. For legacy support an additional
controller will be needed, and for CTO orders please also select the Legacy mode settings part, 758959-B22.
− HPE Smart Array S100i SR Gen10 SW RAID is off by default and must be enabled.
− The S100i uses 14 embedded SATA ports, but only 12 ports are accessible.
− The S100i supports Windows only.
− Supports up to 2 NVMe drives maximum via system board direct connection only.
− Does not support CM6, CD6, P4xxx, and PE80xx NVMe drives.
− For Linux users, HPE offers a solution that uses in-distro open-source software to create a two-disk RAID 1 boot
volume. For more information visit: https://downloads.linux.hpe.com/SDR/project/lsrrb/
•
Intel® Virtual RAID on CPU (Intel® VROC)
Notes: Requires selection of Second Processor.
Essential RAID Controller
• HPE Smart Array E208i-a SR Gen10 Controller
• HPE Smart Array E208i-p SR Gen10 Controller
• HPE Smart Array E208e-p SR Gen10 Controller
Performance RAID Controller
• HPE Smart Array P408i-a SR Gen10 Controller
• HPE Smart Array P408i-p SR Gen10 Controller
• HPE Smart Array P408e-p SR Gen10 Controller
• HPE Smart Array P816i-a SR Gen10 Controller