User manual

PROMIX230DSP HQPOWER
7
38. Unbalanced Master Output (Low)
Output is provided by standard unbalanced phono sockets. Level = 0dBu (775mV RMS), output impedance = < 50,
load impedance = 5k max.
39. AC Power Socket
A standard IEC socket is provided to connect the mixer via the supplied lead to the local AC power supply. The power
consumption of this mixer is 15V.
WARNING: THIS MIXER MUST BE EARTHED FOR SAFETY AND GOOD GROUNDED PRACTICES IN MIXING
In the event of ground-loop problems in the audio system, DO NOT disconnect the AC supply earth to any equipment before
consulting the equipment instruction manual. Most power amplifiers have audio ground lift switches or are designed
specifically to avoid ground-loop problems connected to earthed mixers.
Ensure the mixer has a clean AC supply from the mains socket that is not used for other equipment that would lead to
interference such as lights, refrigerators, etc.
The IEC power socket has an internal fuse holder that takes a 20mm fuse. Always replace a blown fuse with the same type
as specified on the rear of the mixer. Always disconnect the AC power cord before changing the fuse.
40. Earth Stud
This is an earth point for auxiliary equipment, e.g. a turntable.
5. Technical Specifications
Parameter Mic Phono CD/Line
Sensitivity - 52dBu (2mV) - 42dBu (5.5mV) - 8dBu (300mV)
Input Impedance 2k 47k 50k
S/N Ratio > 65dB > 75dB 64dB
Frequency Response 20Hz ~ 26kHz RIAA 20Hz ~ 26kHz
THD < 0.05% < 0.005%
Microphone Equalisation
HI = ± 12dB @ 6kHz
LO = ± 12dB @ 80Hz
Microphone
Override Depth - 12dB on music channels
Music Channel Equalisation
HI = ± 12dB
- 26dB @ > 10kHz
MID = ± 12dB @ 1kHz
- 26dB @ 1kHz
LO = ± 12dB
- 26dB @ < 100Hz
Headphones
Load 32 min.
Power 125mW (2.0V RMS) @ 32
Output Level (Unbalanced)
Low 0dBu (0.775mV RMS)
High + 6dBu (1.55V RMS)
Max. Output (w/out clip) + 16dBu (4.88V RMS)
Headphones
Load 32 min.
Power 125mW (2.0V RMS) @ 32
Dimensions 254 x 120 x 341mm
Weight 4.2kg
Power Supply 230VAC/50Hz
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or
injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.hqpower.com.
The information in this manual is subject to change without prior notice.