Datasheet

VDPLW1028_v2 VELLEMAN
5
5
Fade-in
and
fade-out
Speed
1
Speed
2
Speed
3
Speed
4
- + - - - -
6 Auto
Speed
1
Speed
2
Speed
3
Speed
4
- - + - - -
7
Chase
light
Speed
1
Speed
2
Speed
3
Speed
4
- - - + - -
8
Sound-
activated
strobe
- - - - - - - - + -
9
Sound-
activated
colour
change
+ - - - - - - - + -
Remarks: By activating DIP switch 1, 2 and 3 you can control and choose the colours; by activating DIP switch 8 the
device will be music-sensitive while the sensitivity is controllable through the potentiometer knob; speed 1
means slow, speed 4 means fast.
• Synchronization / master and slave: Set the DIP switches as follows:
Master light: DIP switches are set the same as the auto model. All slave lights: Position switches 1 and 10 on ON.
Position switches 2 to 9 on OFF.
• Special manual controller:
Connect the controller with the VDPLW1028 trough a 3-pin XLR cable. Set DIP switch 1 and 10 to ON for all units
that have to work with the controller.
• DMX512 model:
Set switch 10 to ON to receive the DMX signal; switches 1 to 9 are used to select the requested address.
1 2 3 4 5 6 7 8 9 10
1 2 4 8 16 32 64 128 256 *
Example: If the start address should be 95, the settings would be (for switches 1-10): 1111101000 (1 + 2 + 4 + 8 + 16
+ 0 + 64 = 95).
This unit has 13 channels, below you find all functions:
Ch 1: function selector
0 - 10 dimmer (Ch2 - 13 dimmer valid)
11 - 51 strobe (Ch2 - 13 dimmer valid)
52 - 91 RGB colour fade (Ch2 - 13 no valid)
92 - 131 RGB colour step (Ch2 - 13 no valid)
132 - 147 Chase 1 – green-red
148 - 164 Chase 2 – blue-green
165 - 181 Chase 3 – magenta-green
182 - 198 Chase 4 – yellow-blue
199 - 215 Chase 5 – blue-red
216 - 232 Chase 6 – all colours effect 1
233 - 255 Chase 1 - 6 – all colours effect 2
Ch 2: 0-255 Red dimmer
Ch 3: 0-255 Green dimmer
Ch 4: 0-255 Blue dimmer
Ch 5 – Ch 13: Adjustable brightness from segment 1 to 3 in RGB.