Specifications
RC UNI/AIRC02
ENGLISH
INSTRUCTIONS
1. Panel description
2. Installing the battery
Turn the battery cover of the remote control anticlockwise and remove
the battery cover. then take out the transparent insulator from
compartment. Install one button battery (CR2032). Make sure the
anode (+) is upwards. Put the battery cover back and turn clockwise.
The LCD display will indicate “0” in the lower corner.
3. Set up instructions
a) Turn on air conditioner and aim the remote control
directly at it.
b) Hold the “SET” button until the code flashes in the
mode window.
Repeat pressing “SET” until the air conditioner can
switch ON andOFF automatically. Then press OK
button; setup is complete.
S
E
T
O
K
M
O
DE
ON/OF
F
T
EM
P
C
O
D
E
:
1
8
9
C
A
U
T
O
Method A: manual code search set up.
1
9 Run mode display
12 Signal sending display
2 Blowing direction
display
3 Model code
14 Temperature “-“ key
15 Mode key
16 Automatic blowing
direction control key
6 Power key
17 Enter key
8 SET
5 Fan key
7 Blowing direction
control key
4 Temperature “+” key
1 Fan display
10 Temperature display
11 Temperature
regulation display
13 Power checking
SET
OK
MODE
ON/OFF
TEMP
CODE:
189
C
AUTO
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Method B: direct code setup.
a) Refer to the CODE FORM and find the number corresponding with your
brand. Power on the air conditioner by hand. For example: INYCIN is
code 188-190.
b) Hold the “SET” button (for about 5 seconds) until the code flashes in the
mode window. Repeat pressing “SET” until the code you want to choose
is shown.
c) Press “OK” and the code stops flashing.
d) Check whether the keys on the remote control work normally. If not,
repeat steps b-d until a suitable code is found.
4. Notes
Make sure the air conditioner is in working order. Be aware that the remote
control cannot increase the functions of the air conditioner. If the remote
control will not be used for a long time, make sure to remove the batteries to
prevent damage to the remote control.
Safety precautions:
To reduce risk of electric shock, this product should ONLY be opened by an
authorized technician if service is required. Disconnect the product from
mains and other equipment if a problem should occur.
Warranty:
No guarantee or liability can be accepted for any changes and modifications
of the product or damage caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
2