Operating Instructions
- 28 -
Install adapters by following these steps:
Place/plug in the connecon plug onto the circuit board
Insert and screw down the baery adapter
Design 4
Loosen the athead screw in the middle of the boom of the
baery adapter.
Aer loosing the baery adapter the connecon plug must be removed from the board.
Hereto the small locking mechanism needs to be pushed to open it. Then the plug can
be removed. In order to connect a new baery adapter the locking mechanism must be
locked again.
Design 3
Loosen the two torx screws on the boom of the adapter by
approx. 8 - 10 turns to the le.
Design 2
Loosen the torx screw in the middle by approx. a quarter of a
turn to the le. Do not loosen the screws to far, because the nut
can be loosen then too.
Design 1
Rotate the two athead screws approx. half a turn.
loosen (CW)
mount (CCW)