User manual

Pulse generator ZTG
Serie17,5mm
universal
APPROVALS
MOUNTING
Snap-on mounting using a standard DIN rail EN 50022.
The unit is designed to allow side-by-side mounting, with an
ambient temperature of < 60°C.
OPTIONS
TIMING RANGES
4 timing ranges, abjustable by DIP switch
Pulse Pause
0,15 - 3 s 0,15 - 3 s
1,5 - 30 s 1,5 - 30 s
15 - 300 s 15 - 300 s
3,0 - 60 m 3,0 - 60 m
Other timing ranges and voltages available upon request.
PART NUMBER
011172 ZTG1 24V/230V 1 changeover
011173 ZTG2 24V/230V 2 changeover
APPLICATION
Time control
DESCRIPTION
FUNCTION
Beginning with pulse
The ZTG Pulse generator offers an independent regulation of
the pulse and pause times, which are each adjusted with two
independent potentiometers and DIP switches which are
located on the front panel of the unit. The timer can operate on
either 230V AC using terminals A1 and A2 or 24V UC using
terminals A3 and A2. The green LED indicates the connection
of the power supply.
The timing begins with the connection of the power supply to
the terminals A1 and A2 or A3 and A2. The timing begins with a
pulse. This is indicated by the yellow LED. Upon completion
of the selected delay time on the potentiometer t, the output
i
contact switches into its rest position. After completion of the
selected timing cycle on potentiometer t , the output relay
p
again switches into its working position. This sequence will
repeat itself as long as the power supply is connected. Should
the power supply be interrupted during the reset time, then the
relay returns to its original state. This also applies if the power
is disconnected during the timing period.
FUNCTION DIAGRAM
H
S
B
Industrieelektronik
HSB Industrieelektronik
Hans-Bördlein-Str. 10
97723 Reith
Tel.: +49 9736 / 75759 - 0
Fax: +49 9736 / 75759 - 20
info@hsb-electronics.de
www.hsb-electronics.de
Beginning with pause
The timing beginns with connection of the power supply to the
terminals A1 and A2 or A3 and A2. The timing begins with a
pause. Upon completion of the selected delay time on the
potentiometer t , the output contact switches to its working
p
position. This is indicated by the yellow LED. After completion
of the selected timing cycle on potentiometer t, the output
i
contact switches into its rest position. This sequence will
repeat itself as long as the power supply is connected. Should
the power supply be interrupted during the duration reset time,
then the relay returns to its original state. This also applies if
the power is disconnected during the timing period.
ti
ti
pulse time
A1 (A3) / A2
15 25A1
A2
16
18
26
28
contact 15,25
contact 15,25
16,26
ti
ti
tp
tp
tp
18,28
tp
pause time
A3B1

Summary of content (2 pages)