Instructions for Use

TECHNICALPARAMETER
*The technical parameter information is updated without notice. You can find the latest information on the official website!
S600
DesignedbyHSDJETS.PrintedinChina
Wingspan1293mm/50.9in
Length:1143mm/45in
Height292mm/14.5in
TakeOffWeight1720g/60.7oz(3S)
MaterialEPO+CarbonFibre+ABS+E-PTU
FlightTime15Mins(CruiseControl)/8Mins(StuntMode)
TakeoffType:RunwayTakeoff,HandLaunch
LandingType:RunwayLanding,ParachuteLanding
Motor:2815/1100KV,BrushlessOutrunner
ESC:(1)20ABrushlessESCand(2)40ABrushlessESC
Servos124PCSMetal
Propeller10×7.0inFold
EDFPowerSystem:50mm8-BladeEDF
LightingSystem4ColorsLEDs(FuselageandMainWings)
LandingGearFixedCarbonFiber+E-PTUCushionTyre
Packing3DFoamBox+FlipPortableColorBox+Carton
AirplaneSpecifications
T8FBsize:173×10206mm,R8EFSize:48.5×21×11mm
Weight:470g(includingR8EF)
Frequency:2.4GHzISMband(2400MHz2483.5MHz)
Modulationmode:GFSK
Channelbandwidth:400KHz
Channelpacing:1200KHz
Spreadspectrum:FHSS
Adjacentchannelrejection:>36dBM
Transmitterpower:<100mW(20dBM)
Sensitivity:-104dBM
Speedrate:38kbps
PWMoutput:1.0ms2.0ms
Sectionprecision:2048,0.5uspersection
Cycle:15ms/perframe
RadioT8FBoperatingvoltage:4.8V18V
RadioT8FBoperatingcurrent:<80mA
ReceiverR8EFoperatingvoltage:4.6V10V
ReceiverT8FBoperatingcurrent:<30mA
Supportreceivers:R8EF(Standard),R8FM,R4FG,R4F
AbsoluteCeilingofa/c:-500m
Maxflyingrangeofa/c:-1000m(Theactualflyingrangealsodependsontheflyingenvironment)
TransmitterSpecs(RTF)
BatteryType3SLiPO
Capacity3200mAh
Voltage11.1V
Dischargerate15C
Energy35.52Wh
InternalResistance≤18mΩ
StandardChargeTime4Hours(ReferenceInstructions)
FastChargeTime2Hours(ReferenceInstructions)
StandardDischarge30AContinuous,9VCutoffVoltage
Charger2.6V/3ASmartCharger
Size31×64.5×124mm
Weight255±10g
RecommendedUsageTemperature5℃〜40℃
RestPeriodRecommended30MinutesRestBetweenChargingandDischarging.
SmartBatterySpecs
INSTRUCTIONS
2. Always check the power level of your Smart
Flight Battery by pressing the Red Power button
onthebattery.CheckthenumberofLEDbarsthat
lightupGreen.Alwaysstartyourflightwithafully
chargedSmartFlightBattery.Donotstartaflight
ifthebatteryisshowingbelow2barsofLED.
AC Po w er
Charging
Chargingfull
S600
Timeneededforelectricity:
about90minutes
High   Electricity   Low
- 06 - - 07 -
©Copyright2017HSDJETS.
1.Youcan watchS600videos forinstructions,reviews,andtutorials
byvisitingwww.hsdjets.comandourYouTubeChannelHSDgo.Ifyou
have any questions, you can contact us via email, and or our Social
Mediahubs.
3.Forchargingthe Smart FlightBattery, please usethechargersupplied by HSDJets for your
S600. Connect the charger to AC Power (100-240V, 50/60HZ). Charge time to Fully Charged is
approximately90minutesdependingonhowmuchofthebatterywasusedbeforecharging.
5. Turn on your transmitter and Install the Smart Flight Battery by removing the canopy cover.
Slide the battery into the battery tray and press firmly. Please check the battery has been
connectedtightly.Onceyourflightiscomplete,removetheSmartFlightBatteryfromtheS600.
4. For the HSD-T8FB Transmitter, 4AA
batteries are required and not included.
Please u se a quality brand al k a l i n e
battery. Always fly with good powered
batteries in your transmitter. Remove the
back battery cover and install the AA
batteries.TakenotetheAAbatterypolarity
toinsuretheyarenotinstalledwrong.
Applicableto
2S4SLi-Po(JST
Plug)or4pieces
AA(1.5V)
batteries.