Operating instructions
english
english
18 Classic 411.2 09/2011
Cutting type Strip cut Cross cut
Shred size (mm) 5.8 3.9 3.9 x 50 1.9 x 15 0.78x11 1 x 5
Sa fe ty ra ting DIN 32757 – 1 2 2 3 4 5 Level 6*
Cutting ca pa ci ty ** (sheets), DIN A4 70 g/m
2
80 g/m
2
65 - 67
51 - 53
48 - 50
38 - 40
38 - 40
33 - 35
26 - 28
20 - 22
17 - 19
12 - 14
11 - 12
10
Cutting speed 100 mm/s 110 mm/s
Weight 74 kg 82 kg
Noise level (Idle running/ load) 60 dB(A) / 68 dB(A) 60 dB(A) / 75 dB(A)
Lo ading width 400 mm
Voltage 230 V, 50 Hz
100 V, 50/60 Hz – 115 V, 60 Hz
Power for the maximum number of sheets 2100 W
Dimensions W x D x H (mm) 595 x 470 x 990
Volume of shredded material bag 146 l
* HSM-specifi cation
10 Technical data
Applied standards and technical specifi cations:
• EN 55014-1:2006 • EN 61000-4-2:1995 + A1:1998 + A2:2001
• EN 55014-2:1997 + A1:2001 + A2:2008 • EN 61000-4-4:2004
• EN 61000-3-2:2006 • EN 61000-4-5:2006
• EN 61000-3-3:1995 + A1:2001 + A2:2005 • EN 61000-4-6:2007
• EN 13849-1:2008 • EN 61000-4-11:2004
• EN 62233:2008 • EN 50366:2003 + A1:2006
• EN 60950-1:2006 + A11:2009 + A1:2010
EC Declaration of Conformity
The manufacturer HSM GmbH + Co. KG, Austraße 1 - 9, D-88699 Frickingen hereby declares that the machine,
referred to here as
document shredder HSM Classic 411.2
corresponds to the health and safety requirements of the following EC directives listed below due to its conception and
design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Frickingen, 01.03.2011
Rolf Gasteier - Technical Director
** The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one specifi ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.
The performance data in 80 g/m² is calculated.