Operating instructions

06/2013 SECURIO B 32 11
english
1 Proper use, warranty
The shredder is designed for destroying
paper. Depending on the cutting type, it can
also handle small quantities of the following
materials:
Shred width (mm) 5.8 3.9 4.5x30 1.9x15
Credit and charge cards ●●
CDs ●●
Check the name plate on the back of the
machine to nd out the cutting width and
mains voltage for your document shredder
and observe the applicable instructions in
the operating manual.
2 Safety instructions
Classi cation
Safety notice Explanation
WARNING Failure to observe
this warning can
lead to serious or
fatal injury.
Notice Failure to observe
this instruction can
cause damage.
Before using the machine for the
rst time, read the operating man-
ual, and keep it for later use and to
pass on to any subsequent users.
Observe all safety instructions on to the
machine.
WARNING
Dangerous for children and
others!
The machine may not be used by
persons (including children under
14 years of age) with limited physi-
cal, sensory or mental capabilities
or with a lack of experience and
knowledge, unless they are supervised by
a responsible person or are instructed by
them on the use of the machine. Children
must be supervised to ensure they do not
play with the machine. Do not leave the
document shredder switched on when it is
unattended.
Note: Document shredders with a particle
cutting unit also come with an optional de-
vice for lubricating the cutting unit. Note the
documentation enclosed for the oiler if your
machine is equipped with one.
Its sturdy drive mechanism is not damaged
by paper clips and staples. Only on ma-
chines with a cutting width of 1 x 5 mm can
the paper not contain staples or paper clips.
The warranty period for the document
shredder is 2 years. There is a special war-
ranty for the HSM solid steel cutting roll-
ers in the document shredder, which is
provided independently of the guarantee,
and remains valid for the entire service life
of the machine (HSM Lifetime Warranty).
This does not apply to document shredders
with cutting widths of 0.78 x 11 mm and
1 x 5 mm. This warranty and guarantee ex-
clude wear and damage caused by improp-
er handling or actions taken by third parties.