Quick start Guide

1. With the phone facing up,

insert the tip of the tray eject

tool that came in the box (or

a small b ent paperclip) into

the tray eject hole.

Push the

tip all the way into the hole

until the card tray ejects.

Pull the tray out.

2. With the nano SIM card’s

gold contacts facing down,

place the card into the SIM

holder of the tray.

Make sure to align the cut-

off corner to the notch on

the holder.

3. With the microSD card’s

gold contacts facing down

and narrow side facing in,

place the card into the SD

holder of the tray.

gold contacts

cut-o

corner

nano SIM

gold contacts

microSD

___ Inserting nano SIM and microSD cards

HTC U Ultra

IMPORTANT:

Use a standard nano SIM only.

Don’t cut a micro or regular SIM card and insert it into the

nano SIM slot. It’s thicker than the standard nano SIM card and

may get stuck in the slot.

Don’t disassemble any part of the phone.

Don’t try to open the phone or remove the battery by force. This

may damage the phone or its electronics and will invalidate the

warranty.

Don’t throw the tray away.

You need it to insert your nano SIM and microSD

™

cards.

PAGE 1
HTC U Ultra ___ Inserting nano SIM and microSD cards IMPORTANT: Use a standard nano SIM only. Don’t cut a micro or regular SIM card and insert it into the nano SIM slot. It’s thicker than the standard nano SIM card and may get stuck in the slot. Don’t disassemble any part of the phone. Don’t try to open the phone or remove the battery by force. This may damage the phone or its electronics and will invalidate the warranty. Don’t throw the tray away. You need it to insert your nano SIM and microSD™ cards. 1.
PAGE 2
4 4. When reinserting the tray, make sure it is facing up so that the cards don’t fall out. Hold the tray with the microSD card holder between your fingers, and then steadily slide the tray all the way into the slot. ___ Restarting the phone To restart your phone when it doesn’t respond to touch screen or button presses, press and hold the POWER and VOLUME DOWN buttons (for 12 to 15 seconds) until the phone vibrates, and then release the buttons.