Use and Care Manual

Assembly Instructions
All units in the Heavy Duty Pedestal Family will start with the assembly of
the basic pedestal. Tools needed: (2) 7/16'' wrenches and a putty knife.
1. Unpack and make certain all parts and hardware are included and are
not damaged from shipment.
2. Attach each foot to the Main Tube,
using (2) 1/4"- 20 x 3/4" bolts, installed
through the face of the part, then
through the holes in the Main Tube.
Secure with (2) 1/4" Lock Washers and
(2) 1/4" Hex Nuts from the inside of the
tube. Be sure the threaded boss for
the Leveling Glide will face down when
the unit is fully assembled, and the
short leg of the foot is positioned as
shown. Repeat the procedure on the
remaining 3 feet.
3. Once all 4 feet are attched to the Main Tube, join them together by
inserting a 1/4"- 20 x 3/4" Hex Bolt through the hole in the short leg of
the foot, through adjoining foot, and secure with 1/4" Lock Washer and
Hex Nut.
4. Install the Leveling Glides and adjust as needed.
5. Install the Crank Handle into the Main Tube.
6. Inset the Wedge into the Main Tube.
HGP-10 Assembly
1. Attach the top mounting plate to the wedge with (2) 5/16" - 18 x 2-1/4"
carriage bolts from the bottom with flat washer, lock washer, and hex
nut on top. Pre-plan the carriage bolt locations for mounting user
supplied grinder. Flat washers (2), hex nuts (2) and jamb nuts (2) are
supplied to secure grinder. Flat washers (2), hex nuts (2) and jamb nuts
(2) are supplied to secure grinder.
HGP-12, 18 Assembly
1. Attach the top mounting plate to the wedge with (2) 5/16" - 18 x 1" Allen
bolts, washer, lock washer and 5/16" - 18 Hex nut.
HSS-10, HRT-10, HSS-15/18, HVR-15/18 and HSV-15/18 Assembly
1. Attach Top Bracket to 5006 wedge using 5/16" - 18 x 1" Allen bolt,
washer, lock washer and 5/16" - 18 Hex nut.
2. For model numbers with rollers, use a putty knife like a shoehorn, insert
the fixed end of the roller into the bracket and “snap” the spring-loaded
end into place.