User's Guide

 If you don't see the earbud shown in the list, reset it by quickly tapping
5 times on earbud. The LED on the earbud will flash red several times.
Put the earbud back in the charging case to complete the factory reset.
 If pairing fails, put the earbud back in the case and try again.
 When the earbud is on and hasn’t connected to any mobile device,
they will continue to search for devices. The earbud will turn off
automatically after 5 minutes.
3. Once paired, the earbud will automatically connect to your mobile device
when taken out of the charging case.
4. When you're not using the earbud, place it in the charging case to charge
it. Recharge the case with a 5V charger periodically.
Controls
Power on/off Earbud will turn on when removed from the charging case
and turn off when it is put back in the case.
Play next Tap and hold the earbud for 2 seconds.
Play previous Tap and hold the earbud for 5 seconds.
Play / Pause Tap earbud.
Answer call / End call Tap earbud.
Decline call Tap and hold earbud for 2 seconds.
Assistant Triple-tap earbud.
LED notifications
Charging case LED
: Over 30% charged
:
Over 60% charged
:
Fully charged
 Flashing blue: Connected to power and charging
 Blue on all LEDs: Case is fully charged
 Flashing blue on the first LED: Low battery warning
 Blue: Charging the earbud
Earbud LED  Red: Charging
 Blue: Pairing
 Off: Fully charged or paired with mobile device
Technical specifications
Bluetooth version 5.3
Sweat and water resistant IPX4
Noise cancellation
ENC