User Manual

6
st
1 Installation method
T
R
R
T
Calibration
(1)Place the beam sensor on the same height.
(2)Ensure the beam sensor is vertical
(the bubble of the horizontal pipe should be in the middle).
(3)Adjust the direction of the beam sensor to make them align with each other.
Calibration Hole:used to find another device.
LCD Display:used to know how well the beam sensor be aligned
with each other (the LCD Display will shut down in an hour).
(4)b
(5)Tighten the screws to ensure the position and direction will
not be moved easily.
leep prompt and LCD display more than “100” means the beam
sensors work properly,Please note: “100” is a reference value,
different weather will get different value and bigger value means
better alignment
Step 8
Installation
4