User Manual

8
Step 1
Step 2
(2)How to delete the sensors of the wireless alarm receiver
Power on the wireless alarm receiver by the power adapter
Press and hold both the “ON/OFF” button and “Tone for 10 seconds
and release the buttons when you heard a long bleep;
Note: all the sensors will be deleted by this operation;
” button
ON/OFF
Tone
Step 3
Trigger the (for example,trigger the solar&wireless photoelectric beam sensor)sensor
(a ring tone prompt and the indicator light stops
flashing means the sensor has been added to
the wireless alarm receiver successfully)
stop flashing
Step 4
Trigger the sensor again to confirm the sensor has been added to the wireless alarm
receiver already.
Step 5
Press“Tone ”Button to choose the ring tone for this sensor,there are 35 tones to choose
from
Tone