Instruction Manual

Note: If you decide not to use Carvera for a long time, please keep a tool clamped in the spin-
dle, but do not use the wireless probe. It will reduce the elasticity of the tool clamp without a
tool for long time. The wireless probe cannot be charged automatically if it is not in the tool
holder.
Test Auto Tool Changer
Auto tool changing is one of the key features of Carvera and also the base of all the automated func-
tion. Please test it at the first time.
1. Open the control software and connect to Carvera.
2. Change to tool 1. The tools that pre-installed in the machine is tool 6. Click tool status; click
“Change…”; choose “Tool: 1”, it will automatically change to tool 1. Please observe the process to see if
there is any error.
3. Change to wireless probe. If no error occurred, then test wireless probe. Click tool status; click
“Change”; select “Probe”, it will automatically change to wireless probe and check its signal. Please
observe the process to see if there is any error.
4. Change back to tool 1. Please follow step 2.
If you have any problems or enquiries, please feel free to contact us:
[e-mail]
21
Preparation
20
Preparation