Instruction Manual

7.1. Manual control: Same function as the arrow button on the right side of the interface. Switch to

display manual control interface and file preview interface .

7.2. Device status diagnose: Check and your Carvera in detail and debug. No need to use it when

Carvera runs in good condition. We will add a tutorial in the formal version of the instruction manual.

7.3. WiFi configuration: Refer to the previous WiFi setting instruction in chapter 4.

7.4. Wireless Probe Pairing: See the next chapter for detailed information.

7.5. Software Upgrade:

7.5.1. Controller: Controll software upgrade

7.5.2. Firmware: Firmware upgrade

7.5.3. Download: Link to the download page

7.5.4. Upgrade：For control software, just install the new version and you are ready to use. For

firmware, you need to upload it to the machine using the control software

7.5.5. Check at Startup：Check software updates and notice at the startup

Note: You need to click the Apply button to save all parameters after changing them

and rebooting the machine to apply changes. Parameter introduction and recommend-

ed settings are provided in the parameter list. We will add more detailed parameter

introductions and setting suggestions in the online instruction manual.

8.1. Parameters settings:

8.1.1. Basic parameters: Adjust functional parameters by requirements.

8.1.2. Advanced parameters: System-level of the machine. All set in the factory generally does

not need to be changed. Do not change it unless it has to.

8.1.3. Restore setting: Restore factory setting, or save current setting as factory setting.

Note: Carvera has already set the coordinate offset of the laser before delivery, only reset it when the

coordinates deviate. We will add relevant tutorials in the online instructions.

6、Laser status and control

7、Other functions

6.1. Symbol: Laser icon

6.2. Main data: Current laser rate

6.3. Sub-data: Laser power scale

6.4. Drop-down list:

6.4.1. Laser Status: Laser power scale

6.4.2. Enable Laser: Switch to laser mode. The working coordinates will be automatically updated

according to the preset offset. If there is a tool on the current spindle, Carvera will drop it first and

calibrate again to check the laser head’s height.

6.4.3. Laser Test: Performing a laser test after turn on the laser mode will trigger a low-power

laser beam for focus calibration.

6.4.4. Power Scaling: Set the laser power range by percentage. For safety reasons, the adjustment

amount range is limited from 50% to 200%.

Software