Instruction Manual

4.2. Click the “Start Pairing” button, and the machine will enter pairing mode. （You have 30 seconds to

finish the pairing, need to do it again in case time is out）

4.3. Trigger the wireless probe for around 10 seconds until the green LEDstart to blink quickly, which

means the wireless probe enters pairing mode.

4.4. If pairing succeeds, the green LED will blink 5 times slowly.

4.5. If pairing fails, the LED will be switched off. Please do it again.

4.6. You can go to diagnose the window to check if the wireless probe was paired successfully.

5. Test: Open the drop-down list in status toolbar and select the diagnostic function, the diagnostic

status dialog box will pop up. Press the wireless probe and you can see the Probe signal is triggered,

indicating the wireless probe is working.

Note: Unlike crash of milling bits, the crash of wireless probe may cause serious damage

to the probe. Please use the wireless probe with caution. Always observe its traveling

path, and stop the machine when finding any obstacles to protect the wireless probe.

Wireless Probe

1. Charging: The wireless probe needs to be charged when it is used for the first time or after the

machine has not been used for a long time (more than a week). The wireless probe will automatically

start charging after turn on the machine. The charging indicator yellow light will be on and go out when

it is full. You may start using it after the voltage reach 3.7v, no need to wait for full charge.

2. Probing: When the wireless probe is triggered, the green indicator light turns on.

3. Laser indicator: Press the wireless probe twice to turn on the laser indicator (used for manual tool

setting of the XY axis). The laser indicator will also be turned on automatically when scanning the path

area.

4. Pairing： The wireless probe that comes with the machine has already been paired to the machine by

default, you can use it directly. For optional backup wireless probes, you need to pair it first:

4.1. Open the pairing wireless probe popup window in the control software.

Tool Kit