Instruction Manual

Note: A lens protective cover is installed by default. Make sure to remove it before using
the laser function and install it back when not in use.
Note: Always wear laser protection goggles when using laser function.
Note: To use the Carvera laser function, you must first enter the laser mode. The com-
mands for entering and exiting the laser mode are: M321 and M322, please add them in
the G code post-processing.
Laser Module
The Carvera machine has a built-in 2.5W diode laser module, which can engrave wood, plastic, and
other materials, an excellent complement to the CNC function. You don't need to adjust the focus or
offset of the laser module by default because we have done that before leaving the factory. But if you
encounter any problem with them, we will explain the detailed adjustment method in the specific
tutorial on our website.
The Carvera machine has an optional laser protective cover which can greatly reduce the laser radia-
tion. It's suitable for people who intend to use laser function a lot and operate at spaces where
children or bystanders can reach easily. You can choose this accessory at our online store.
Spindle Collet Installer
Carvera comes with a 1/8 inch(3.175mm) tool clamp. This is the common used size for desktop level
CNC machines, which can meet most machining requirements. For special sizes such as
4mm/6mm/6.35mm, you can change the tool clamp and the tail shaft of the wireless probe.
1. Change spindle collet: Use the control software to drop the current tool, insert the spindle collet
installer into current collet, rotate counterclockwise to remove current collet. Use the same way to
install the new collet.(don't tighten too much for future exchange)
2. Change tail shaft of wireless probe: Rotate the wireless probe’s tail shaft counterclockwise to
remove. Use the same method to change the new tail shaft.(don't tighten too much for future
exchange)
Tool Kit
Tool Kit
52 53