Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
Figure 13-2 Adjusting the horizontal azimuth of an antenna (1)
(1) Normal line of an antenna (2) Geologic compass
2. Tighten the screws on the angle adjusting component to 6 N·m (53.1 lbf·in.).
l Adjusting the horizontal azimuth of an antenna installed on the top of a pole
1. Lift the landscaping cover until it is stuck above the elastomer.
2. Loosen the screws on the mounting bracket, and rotate the mounting bracket based
on the coverage requirements, as shown in the following figure.
AAU3940
Installation Guide 13 Adjusting the Horizontal Azimuth of an Antenna
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
91