Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
16 Appendix
About This Chapter
This chapter describes auxiliary operations during an AAU installation process.
16.1 Assembling the OT Terminal and the Power Cable
There are two types of OT terminal: one-hole OT terminal and two-hole OT terminal. This
section describes the procedure for adding an OT terminal to a power cable by taking a one-hole
OT terminal as an example.
16.2 Adding a Tool-Less Female Connector (Pressfit Type) to an AAU Power Cable on the AAU
Side
This section describes the procedure for adding a tool-less female connector (pressfit type) to
an AAU power cable on the AAU side.
AAU3940
Installation Guide 16 Appendix
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
97