Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
16.1 Assembling the OT Terminal and the Power Cable
There are two types of OT terminal: one-hole OT terminal and two-hole OT terminal. This
section describes the procedure for adding an OT terminal to a power cable by taking a one-hole
OT terminal as an example.
Context
Figure 16-1 shows a one-hole OT terminal and materials related to a power cable.
Figure 16-1 one-hole OT terminal and materials related to a power cable
A heat shrink tubing
B. one-hole OT terminal
with a bare crimping
terminal
C. Insulation layer of a power
cable
D. Conductor of a power
cable
Figure 16-2 shows a two-hole OT terminal and materials related to a power cable.
AAU3940
Installation Guide 16 Appendix
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
98