Installation Instructions

Table Of Contents

Step 2 Strip a specified length of sheath off the power cable, as shown in the following figure.

Figure 16-9 Stripping a specified length of sheath

Step 3 Strip the sheath off each core wire, as shown in the following figure.

Figure 16-10 Stripping the sheath off each wire

Step 4 Add a tool-less female connector (pressfit type) to three core wires, as shown in the following

figure.

1. Slide the sliding block on the connector outwards along the direction shown by the arrow.

2. Use an M3 Phillips torque screwdriver to loosen the two screws.

3. Use the M3 Phillips torque screwdriver to loosen the one screw on the other side.

4. Connect the brown core wire to the L port, the blue core wire to the N port, and the green

and yellow core wire to the PE port. Then, use the M3 Phillips torque screwdriver to tighten

the screws to 0.5 N·m (4.425 lbf·in.), as shown in the following figure.

5. Slide the sliding block on the connector inwards along the direction shown by the arrow.

AAU3940

Installation Guide

16 Appendix

Issue 01 (2015-01-15) Huawei Proprietary and Confidential

103