Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
Figure 2-6 ODM installation clearance requirements
2.3 AAU Mounting Kits
This section describes mounting kits for installing AAUs on a pole, a wall, and the top of a pole.
Mounting Kits for an AAU Installed on a Pole or Wall
The same mounting kits are used for installing an AAU on a pole and installing an AAU on a
wall. However, the procedure for installing an AAU on a pole is different from that for installing
an AAU on a wall. The following figure shows the mounting kits for an AAU.
NOTE
When an AAU is installed on a pole or wall, the main bracket and attachment plate are required.
l When an AAU is installed on a pole, M8x80 expansion anchor bolts are not required.
l When an AAU is installed on a wall, steel belts are not required. Therefore, you need to remove the steel
belts from mounting kits.
AAU3940
Installation Guide
2 Overview
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11