Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
6 (Optional) Installing an ODM
This section describes the procedure and precautions for installing an ODM.
Context
The part of a pole for installing the mounting bracket of an ODM should have a diameter of 114
mm to 380 mm (4.489 in. to 14.96 in.).
Procedure
l Installing an ODM on a wall
1. Determine a position for installing an ODM on a wall, use a level to adjust the position
to ensure that the mounting bracket will be placed horizontally, and use a marker to
mark anchor points, as shown in the following figure.
Figure 6-1 Determining a position for installing an ODM
(1) Level
(2) Screw hole (3) Marker
AAU3940
Installation Guide
6 (Optional) Installing an ODM
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25