Installation Instructions

Table Of Contents

l Installing an ODM on a pole

1. Determine a position for installing an ODM on a pole, attach a mounting bracket to

the installation position on the pole, put the steel belts through the mounting bracket,

and wind the steel belts round the pole for one circle, as shown by illustrations a, b,

and c in the following figure.

2. Use an M6 inner hexagon wrench to tighten the bolts on the two steel belts alternately

to secure the mounting bracket to 5 N·m (44.25 lbf·in.), as shown by illustration d in

the following figure.

Figure 6-5 Securing a mounting bracket to a pole

3. Fit the two dowels on the top of the ODM backplane into the mounting bracket, and

push the ODM case until it is attached onto the mounting bracket, as shown by

illustrations a and b in the following figure.

4. Use a double-headed inner hexagon tool to tighten the screw on the top of the

attachment plate clockwise to 7 N·m (61.95 lbf·in.), as shown by illustration c in the

following figure.

AAU3940

Installation Guide 6 (Optional) Installing an ODM

Issue 01 (2015-01-15) Huawei Proprietary and Confidential