Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
Figure 9-1 Putting the steel belt through the sliding block
Step 3 Pull the steel belts to align the holes on the steel belts with those on the sliding blocks, as shown
in the following figure.
NOTE
If the pin on a sliding block is located between two holes on a steel belt after the belt is securely attached
to the pole, slightly loosen the steel belt so that the pin goes through a hole on the steel belt.
AAU3940
Installation Guide 9 Installing an AAU
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
39