Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
Figure 9-3 Securing a main mounting bracket
Step 5 Use a cable cutter to cut off the excess of steel belts and reserve a slack of 20 mm to 30 mm
(0.79 in. to 1.18 in.), and wrap insulation tape around the ends of the belts to prevent personal
injury, as shown in the following figure.
Figure 9-4 Cutting off the excess of steel belts and wrapping insulation tape
(1) Insulation tape
AAU3940
Installation Guide
9 Installing an AAU
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
41