Installation Instructions

Table Of Contents

– If no ODM is configured, add the corresponding connector to the power cable

according to the type of the port on the power equipment.

– If an ODM is configured, add cord end terminals to the end of the power cable

connected to the ODM according to the instructions in Assembling the Cord End

Terminal and the Power Cable.

l Connecting an AAU power cable to an AAU

1. Route an AAU power cable into the maintenance cavity through the rear of the

maintenance cavity.

2. Connect one end of the AAU power cable with a tool-less female connector (pressfit

type) to the power port on the AAU, as shown in the following figure.

Figure 10-14 Connecting an AAU power cable to an AAU

3. Use a clip to secure the power cable, as shown in the following figure.

a. Use an M4 screwdriver to loosen two screws in sequence to open the power cable

clip.

b. Put the power cable through the clip and waterproof trough, and close the clip.

AAU3940

Installation Guide

10 Installing AAU Cables

Issue 01 (2015-01-15) Huawei Proprietary and Confidential