Installation Instructions

Table Of Contents

gel in the cable holes through which no cables are routed because silica gel is required

to provide the waterproof function.

2. Use insulation tape to wrap cord end terminals of the power cable to prevent sharp

edges of the cord end terminal from damaging silica gel.

3. Apply petroleum jelly to the power cable, and then route the power cable through a

cable hole.

4. Use the screwdriver delivered with the ODM to loosen screws on the terminals to

which the power cable is to be connected, and connect the terminals on the power

cable to the corresponding terminals, as shown by illustrations c and d in the following

figure.

5. Tighten the screws on the terminals of the power cable, as shown by illustration e in

the following figure.

6. Securely bind the power cable to the binding bracket, as shown by illustration f in the

following figure.

Figure 10-16 Connecting an AAU power cable to an ODM

(1) Screwdriver delivered with the ODM

(2) Petroleum jelly (3) Insulation tape

AAU3940

Installation Guide 10 Installing AAU Cables

Issue 01 (2015-01-15) Huawei Proprietary and Confidential