Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
Procedure
l Stripping a trunk fiber optic cable and pigtails
1. Use a screwdriver to pierce silica gel in the cable hole on the ODM for the trunk fiber
optic cable, as shown by illustration a in the following figure.
2. Route a trunk fiber optic cable through the cable hole, as shown by illustration b in
the following figure.
Figure 10-20 Routing a trunk fiber optic cable through a cable hole
(1) Screwdriver (2) Trunk fiber optic cable
3. Strip a specified length of sheath off the trunk fiber optic cable, as shown in the
following figure.
AAU3940
Installation Guide
10 Installing AAU Cables
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
75