Installation Instructions

Table Of Contents

Figure 10-21 Stripping a specified length of sheath off a trunk fiber optic cable

(1) Strength member (2) Core wire (3) Bare fiber

4. Strip a specified length of sheath off the pigtail, as shown in the following figure.

Figure 10-22 Stripping a specified length of sheath off a pigtail

(1) Sheath

(2) Core wire (3) Bare fiber

l Installing a trunk fiber optic cable

1. Route the strength member through the hanger, bend the strength member, and tighten

the screw on the hanger to 1.2 N·m (10.62 lbf·in.), as shown by illustration a in the

following figure.

2. Use a finger to press the clip until it snaps into place, as shown by illustration b in the

following figure.

3. Route the core wire of the trunk fiber optic cable through the cable hole in the splicing

tray, and use a cable tie to fasten the core wire, as shown by illustration c in the

following figure.

AAU3940

Installation Guide 10 Installing AAU Cables

Issue 01 (2015-01-15) Huawei Proprietary and Confidential