Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
the corresponding port on the fiber adapter, as shown by illustration a in the following
figure.
3. Use a finger to press the clip until it snaps into place, as shown by illustration b in the
following figure.
Figure 10-32 Connecting a CPRI fiber optic cable to an ODM
NOTICE
To open the ODM case for maintenance, a minimum of 40 mm (1.57 in.) fiber optic cable
is reserved outside the ODM case, as shown in the following figure.
AAU3940
Installation Guide
10 Installing AAU Cables
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
84