Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
12 (Optional) Installing a Cord Cover for an
ODM
This section describes a procedure for installing a cord cover for an ODM after all cables are
installed.
Prerequisites
l An ODM has been installed.
l All cables for the ODM have been installed.
Procedure
Step 1 Optional: When an ODM is installed on a wall or ODM cables are routed along the outer side
of a pole, remove the part from the bottom of a cord cover, as shown in the following figure. If
cables are routed along the inner side of a pole, skip this step.
Figure 12-1 Removing a part
Step 2 Lift the cord cover so that the two round dowels on the top of the cord cover are inserted into
the holes on the bottom of the ODM, and push the cord cover upwards, as shown in the following
figure.
AAU3940
Installation Guide
12 (Optional) Installing a Cord Cover for an ODM
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
87