Installation Instructions
Table Of Contents
- About This Document
- Contents
- 1 Changes in AAU3940 Installation Guide
- 2 Overview
- 3 Installation Preparations
- 4 Unpacking Check
- 5 Installation Process
- 6 (Optional) Installing an ODM
- 7 Preprocessing the AAU Maintenance Cavity
- 8 Lifting an AAU
- 9 Installing an AAU
- 10 Installing AAU Cables
- 11 Closing a Maintenance Cavity
- 12 (Optional) Installing a Cord Cover for an ODM
- 13 Adjusting the Horizontal Azimuth of an Antenna
- 14 Installation Checklist
- 15 Powering on an AAU
- 16 Appendix
Figure 13-1 Normal line of an antenna
(1) Normal line of an antenna
Procedure
l Adjusting the horizontal azimuth of an antenna installed on a pole or wall
1. Loosen the screws on the angle adjusting component, and rotate the angle adjusting
component based on the coverage requirements, as shown in the following figure.
AAU3940
Installation Guide
13 Adjusting the Horizontal Azimuth of an Antenna
Issue 01 (2015-01-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
90