User's Manual

Table Of Contents

Installing the Device on a wall or ceiling requires sheet metal mounting brackets (delivered

with screws), which need to be purchased separately. The procedure is as follows:

1. Determine the target area on a wall or ceiling, attach the sheet metal mounting bracket

against the wall, and mark positions of the mounting holes with a marker.

2. Drill holes at the marked positions and install the plastic expansion tubes.

Ø6

35mm

a. Use a 6 mm drill bit to drill holes at the marked positions.

b. Hammer the plastic expansion tubes into the holes.

3. Use the flat washer and self-tapping screws to fasten the mounting bracket to the wall or

ceiling. If the device is installed against the wall, ensure that UP arrowhead faces

upwards.

AP2030DN

Hardware Installation and Maintenance Guide

2 AP Installation

Issue 05 (2016-07-22) Huawei Proprietary and Confidential