User's Manual

Table Of Contents

Procedure

Step 1 Strip a part of the insulation to expose the cable conductor with a length of L, as shown in

Figure 5-7. The recommended values of L are listed in Table 5-2.

NOTICE

l When you strip a power cable, do not damage the conductor of the cable.

l If the bare crimping terminal is not provided by Huawei, you can adjust the value of L as

required.

Figure 5-7 Stripping a power cable (JG terminal)

Table 5-2 Mapping between the cross-sectional area of the conductor and the value of L

Cross-Sectional Area of Conductor

(mm

(in.

))

Value of L (mm(in.))

16 (0.025) 13 (0.51)

25 (0.039) 14 (0.55)

35 (0.054) 16 (0.63)

50 (0.077) 16 (0.63)

Step 2 Put the heat shrink tubing onto the bare crimping terminal, as shown in Figure 5-8.

AP2030DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 05 (2016-07-22) Huawei Proprietary and Confidential