User's Manual

Table Of Contents

Figure 5-8 Putting the heat shrink tubing onto the bare crimping terminal

Step 3 Put the bare crimping terminal onto the exposed conductor, and ensure that the bare crimping

terminal is in good contact with the insulation of the power cable, as shown in Figure 5-8.

Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in Figure 5-9.

Figure 5-9 Crimping the joint parts of the bare crimping terminal and the conductor (JG

terminal)

Step 5 Push the heat shrink tubing toward the connector until the tube covers the crimped part, and

then use a heat gun to heat the tube, as shown in Figure 5-10.

Figure 5-10 Heating the heat shrink tubing (JG terminal)

AP2030DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 05 (2016-07-22) Huawei Proprietary and Confidential