User's Manual

Table Of Contents

Figure 5-28 Components of an unshielded RJ45 connector and cable

A. Plug of connector B. Jacket C. Twisted-pair wires

Procedure

Step 1 Remove a 16-mm (0.63 in.) long section of the jacket, as shown in Figure 5-29.

NOTICE

When you remove the shield layer, do not damage the insulation of the twisted-pair cable.

Figure 5-29 Removing the jacket of a twisted-pair cable (unit: mm (in.))

Step 2 Align the four pairs of wires and cut the ends neatly, as shown in Figure 5-30. The

connections between the wires and the pins are listed in Table 5-6.

Figure 5-30 Connections between wires and pins (unit: mm (in.))

White-Orange

White-Green

Orange

Blue

White-Blue

Green

White-Brown

Brown

Pin 8

Pin 1

AP2030DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 05 (2016-07-22) Huawei Proprietary and Confidential