User's Manual

Table Of Contents

Procedure

l Install an OT terminal.

a. Align the hole of the OT terminal (conductor upward) with a connecting hole, as

shown in Figure 5-42.

Figure 5-42 Aligning the OT terminal with a connecting hole

NOTE

When you install an OT terminal, the crimping sleeve is installed as shown in Figure 5-43,

where A is correct and B is incorrect.

Figure 5-43 Installing an OT terminal, showing the orientation of crimping sleeve

b. Place the spring washer and flat washer in turn, mount a matching screw, and fasten

it clockwise, as shown in Figure 5-44.

AP2030DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 05 (2016-07-22) Huawei Proprietary and Confidential