User's Manual

Table Of Contents

Figure 5-48 Placing a terminal on a terminal jack vertically

Step 2 Insert the terminal into the jack vertically, and turn the screw clockwise to fasten the terminal,

as shown in Figure 5-49.

Figure 5-49 Feeding the terminal into the jack

NOTICE

l Ensure that the exposed section of the terminal is less than 2 mm (0.079 in.) in length.

l Do not press the insulation of the terminal.

l Insert only one terminal into one jack.

Step 3 Move the cable slightly and ensure that it is securely connected.

Step 4 Before you remove a cord end terminal, loosen the screw counterclockwise.

----End

Installing Ethernet Adapters

AP2030DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 05 (2016-07-22) Huawei Proprietary and Confidential