User's Manual

Table Of Contents

Figure 5-75 Installing a new mold in the COAX crimping tool

NOTICE

Keep the short side of the mold inwards and the long side outwards, with the teeth of the mold

aligning from the larger size to the smaller size.

Step 5 Hold the handles of the COAX crimping tools tightly to match the mold and the jaw

completely. Align the screw holes, as shown in Figure 5-76.

Figure 5-76 Aligning the screw holes

Step 6 Hold the handles of the COAX crimping tools with one hand. Tighten the two fastening

screws clockwise. Figure 5-77 and Figure 5-78shows the mold installed in the COAX

crimping tool.

AP2030DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 05 (2016-07-22) Huawei Proprietary and Confidential