User's Manual

Table Of Contents

Placement of text on a label is shown in Figure 5-84.

Figure 5-84 Placement of text on a label

Attaching Labels

After printing or writing the label, remove the label from the page and attach it to the signal

cable, or the identification plate of the power cable. The methods for attaching labels are

described in the following sections.

Label for Signal Cables

l Choose the place to attach labels.

The label is attached 2 cm (0.79 in.) from the connector on a signal cable. In special

cases (for example, to avoid cable bending or affecting other cables), other positions are

allowed to attach the labels. The rectangular part with text is attached facing right or

downward, as shown in Figure 5-85. The details are as follows:

– The identification card is to the right of the cable in vertical cabling.

– The identification card should be downward when you lay out the cable

horizontally.

Figure 5-85 Text area of the label

l Procedure for attaching labels

Figure 5-86 shows the methods and procedures for attaching labels.

AP2030DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 05 (2016-07-22) Huawei Proprietary and Confidential