User's Manual

Table Of Contents

NOTE

l The AP5030DN and AP5130DN must have cables connected first before installation. Except the two

models, the procedures for installing the other models of indoor APs are the same unless otherwise

stated. The following figures use the AP7110DN-AGN as an example.

l Remove the protective film on the AP surface before installation to prevent electrostatic discharge.

2.5.1 Wall Mounting

Mounting APs on a wall requires sheet metal mounting brackets and expansion screws. The

procedures are as follows:

1. Fix the mounting bracket to the wall, adjust the installation position, and use the marker to

mark the drilling positions where expansion screws are installed.

59mm

85mm

UP UP

2. Use a 6 mm drill bit to drill 25 mm to 30 mm deep holes in the drilling positions. Hammer

the expansion tubes into the holes until the expansion tubes are completely embedded into

the wall.

25mm~30mm

1 2

3. Fix the mounting bracket to the wall and use the Phillips screwdriver to fasten three

expansion screws into the expansion tubes.

AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN

Hardware Installation and Maintenance Guide

2 AP Installation

Issue 12 (2015-08-05) Huawei Proprietary and Confidential