User's Manual

Table Of Contents

NOTE

If you are proficient in assembling OT terminals and power cables, you can obtain the value of L1 by

comparing the part to be crimped with the power cable.

Step 2 Put the heat-shrinkable (A) tubing onto the bare crimping terminal, as shown in Figure 5-3.

Figure 5-3 Putting the heat shrink tubing onto the bare crimping terminal

Step 3 Put the OT terminal B onto the exposed conductor, and ensure that the OT terminal is in good

contact with the insulation coating C, as shown in Figure 5-3.

NOTICE

After the conductor is fed into the OT terminal, the protruding part of the conductor, or L2 in

Figure 5-3, must not be longer than 2 mm (0.08 in.).

Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in Figure 5-4.

NOTE

The shapes of crimped parts may vary with the crimping dies.

AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN

Hardware Installation and Maintenance Guide 5 Appendix

Issue 12 (2015-08-05) Huawei Proprietary and Confidential